COPYRIGHT © 2004 MERIT INDUSTRIES, INC.
ATTENTION:
OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DEVICES
Removal/Installation of Hard Drive -
FORCE Upright Fusion/Fun Zone
Troubleshooting Information - Removal/Installation of Hard Drive -
FORCE Upright Fusion/Fun Zone
Megatouch FORCE Technical Reference Manual
Hard Drive Removal
1. Turn off and unplug the game.
2. Unlock and open the bezel.
Fun Zone games and Fusion games with electronic boxes only
: Remove the 2 screws
fastening the electronics box cover and move the cover aside.
3. Locate the hard drive. It will either be mounted to the electronics box cover or against the back
wall of the game. Remove the 3 screws or standoffs (see Figure 1) securing the hard drive
mounting bracket to the cover or the game, then remove the hard drive assembly until you’re
able to disconnect the hard drive power connector and hard drive ribbon cable.
4. Remove the 4 screws and shoulder washers fastening the hard drive to the mounting plate.
Hard Drive Installation
1. Fasten the new hard drive to the mounting plate with the 4 screws and shoulder washers.
2. Connect the power connector and ribbon cable to the hard drive, then fasten the hard drive
assembly to the electronics box cover or the game with the 3 screws or standoffs. See Figure
1.
3. Close and lock the bezel.
Fun Zone games and Fusion games with electronic boxes only:
Replace the
electronics box cover and fasten it withthe 2 screws.
4. Plug in and turn on the game.
FIGURE 1 - HARD DRIVE
POWER
CONNECTOR
RIBBON
CABLE
HARDWARE
FASTENING
HARD DRIVE
TO MOUNTING
PLATE
(3 PLACES)
SCREWS AND
SHOULDER
WASHERS
FASTENING
HARD DRIVE TO
MOUNTING
PLATE
(4 PLACES)