background image

COPYRIGHT © 2005 MERIT INDUSTRIES, INC.

Power Supply Removal

1. Turn off and unplug the game.

2. Unlock and open the bottom door.

3. Remove the 4 screws securing the electronics box cover.  See Figure 1.  Carefully remove the

cover.

4. Remove the 4 shoulder washers (2 on the left interior wall and 2 on the floor of the electronics

box) securing the power supply assembly to the game.  See Figure 2.

5. Disconnect all connections to the main power supply harness.

6. Remove the power supply.

Power Supply Installation

1.

NOTE:  Before securing the power supply assembly, make sure the ground wire is
secured around the left rear pem stud.

  Install the new power supply assembly in the game

in the same manner as the old power supply.  Fasten with the existing hardware.  See Figure 2.

2. Reconnect all connections to the main power supply harness.

3. Plug the IEC connector into the new power supply.

4. Replace the electronics box cover and fasten it with the 4 screws.  See Figure 1.

5. Close and lock the bottom door.

6. Plug in and turn on the game.

ATTENTION:

OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DEVICES

Removal/Installation of Major Assemblies -

Money Shoot

manuals/manuals_Support_Center_Money_20Shoot_Power_20Supply_20Removal_20and_20Installation_pdf-html.html
background image

COPYRIGHT © 2005 MERIT INDUSTRIES, INC.

FIGURE 1 - CLOSED ELECTRONICS BOX - LOCATED IN BOTTOM OF MONEY SHOOT CABINET

4 S CRE W S  TO  RE MO V E  
E LECT RONICS   B OX  CO V ER

 

FIGURE 2 - POWER SUPPLY AND MOUNTING BRACKET

 

4 SHOULDER 

WASHERS 

SECURING

POWER SUPPLY 

ASSEMBLY