COPYRIGHT © 2001 MERIT INDUSTRIES, INC.
TN55.doc 01/04/02
Tech Notes
Page 1 of 1
Tech Notes
Tech Notes
Date: 12-12-01
merit industries, inc.
Re:
Replacing the I/O Board on a Megatouch Force Game
If you are replacing the I/O board on a Megatouch Force game, make sure the jumpers
at JP5 and JP6 on the I/O board are located in the correct position. The orientation of
the jumpers at JP5/JP6 will determine which USB connector on the I/O board is
activated. If the I/O board is going into a Radion or Classic Force game, the jumpers
must be moved as shown in the diagram below.
http://www.meritind.com
J2
METER
SETUP
CALIBRATE
J8
SMILEY
BILL
ACCEPTOR
J3
MECHANICAL
MECH
J5A
FROM USB PORT
ON MOTHERBOARD
(FOR RADION AND
CLASSIC GAMES)
J6
I/O BOARD
POWER
J1
ELECTRONIC
MECH
DETAIL VIEW
JUMPER LOCATION
FOR ELITE AND UPRIGHT
J5B
FROM USB PORT
ON MOTHERBOARD
(FOR ELITE AND
UPRIGHT GAMES)
DETAIL VIEW
JUMPER LOCATION
FOR RADION AND CLASSIC
SECURITY
KEY
JP5/JP6
JUMPER FOR
USB CONNECTOR
FIGURE 1 - MEGATOUCH FORCE I/O BOARD DRAWING