Bill Acceptor Removal
1. Turn off and unplug the game.
2. Unlock and open the coin/bill acceptor door.
3. Pull out the bill acceptor magazine.
4. Remove the 4 hexnuts and screws securing the bill acceptor to the cash door, as well as the
ground wire secured by one of the hexnuts. See Figure 1.
5. Remove the hexnut securing the bill acceptor ground wire. See Figure 1.
5. Remove the bill acceptor from its housing.
6. Remove the 2 wire connections from the bill acceptor. See Figure 1.
Bill Acceptor Installation
1. Reconnect the 2 wire harnesses at the top and the bottom of the bill acceptor, with a gap left in
between. The 10-pin connector should be plugged in above the 12-pin connector when the bill
acceptor is installed in the coin/bill acceptor door. See Figure 1.
NOTE: Failure to install the
connectors properly will result in game malfunction.
2. Fit the bill acceptor into place on the cash door and secure it with the 4 existing screws and nuts.
One hexnut will also be used to secure the ground wire originating from the back of the game. See
Figure 1.
3. Use the remaining hexnut to secure the bill acceptor ground wire. See Figure 1.
4. Reinstall the bill acceptor magazine.
5. Close and lock the coin/bill acceptor door.
6. Plug in and turn on the game.
ATTENTION:
OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DEVICES
Removal/Installation of Major Assemblies -
Merit Boardwalk
Troubleshooting Information - Removal/Installation of Major Assemblies -
Merit Boardwalk